Anti-Tip Bracket; Electrical Requirements; Installation - GE Profile PB975 Technical Service Manual

Electrical Requirements

Caution: For personal safety, do not use an
extension cord with this appliance.
This appliance must be supplied with the proper
voltage and frequency, and connected to an
individual properly grounded branch circuit,
protected by a circuit breaker or fuse having
amperage as specifi ed on the rating plate. The
rating plate is located on the left-hand side of the
lower oven front frame.
Location of
model rating
plate
You must use a 3-wire, single-phase A.C. 08Y/120
Volt or 240/120 Volt, 60 hertz electrical system. If
the electrical service provided does not meet the
above specifi cations, have a licensed electrician
install an approved outlet.
WARNING: ALL NEW CONSTRUCTIONS, MOBILE
HOMES AND INSTALLATIONS WHERE LOCAL CODES
DO NOT ALLOW GROUNDING THROUGH NEUTRAL,
REQUIRE A 4-CONDUCTOR UL-LISTED RANGE CORD.
Use only a 3-conductor or a 4-conductor UL-listed
range cord. These cords may be provided with ring
terminals on wire and a strain relief device.

Installation

A range cord rated at 40 amps with 125/250
minimum volt range is required. A 50-amp range
cord is not recommended but if used it should
be marked for use with nominal 1
connection openings. Care should be taken to
center the cable and strain relief within the knockout
hole to keep the edge from damaging the cable.
• Because range terminals are not accessible
after range is in position, fl exible service conduit
or cord must be used.
• On some models, a fi lter capacitor may be
connected between the black and white leads
on the junction block.

Anti-Tip Bracket

WARNING:
The range must be secured by the anti-tip bracket
supplied.
WARNING: Unless properly installed, the range
could be tipped by stepping or sitting on the doors.
Injury may result from spilled hot liquids or from the
range itself.
An anti-tip bracket is supplied with instructions for
installation in a variety of locations. The instructions
include all necessary information to complete the
installation. Read the safety instructions and the
instructions that fi t your situation before beginning
installation.
Typical installation of anti-tip bracket attachment to wall
– 26 –
-in. diameter
/
3
8
Wall plate
Bracket
Screw must
enter wood
or metal