GE Profile PB975 Technical Service Manual page 38

To replace the inner door assembly:
Remove the outer door assembly. (See previous
page.)
1. Remove the four T-20 Torx screws (2 on each
side) that attach each door hinge to the inner
door. Carefully turn the door over and remove
both door hinges.
2. Remove the two ¼-in. hex-head screws that
attach the heat defl ector to the heat barrier.
Remove the heat defl ector.
3. Remove the six ¼-in. hex-head screws that hold
the heat barrier to the inner door. Remove the
heat barrier.
4. Remove the insulation and the inner glass
assembly from the inner door.
Inner Glass Assembly
Assembly Notes
When assembling, make sure the hinges are parallel
to each other and perpendicular to the door liner. If
not, the hinge may bind on the receiving channel of
the door. If the new hinge is not in the cocked and
locked position after installing, place the bottom of
the door against a fi rm, protected surface and push
the hinge arm down to the cocked position. Pull the
hinge lock back against the door liner surface to
lock the hinge in this position.
Air enters the door assembly through large slots in
the bottom and fl ows upward between the inner
and outer assemblies, exhausting through slots
in the top of the door. DO NOT INSULATE THIS AIR
CHANNEL.
Arrows on the side of the inner glass assembly
indicate the direction in which the inner oven door
glass is installed. The arrows should be pointing
toward the oven cavity.
OVEN
– 38 –