Signature Command System Operation - Vermont Castings VC31LDVINTSC Installation And Operating Instructions Manual

sIGNAtuRe COmmAND system OpeRAtION INstRuCtIONs
FeAtuRes
Command Center
•
Easy Access Function Operation and System Configura-
tion
•
Operation Confirmation/Fault Diagnostic Indications
(LED/Buzzer)
•
ON/OFF/HI/Med/Low Operation
•
Optional Wall Mounting
Control Board
•
Electronic Ignition
•
Pilot Lockout safety feature
•
Electric Power Regeneration from Thermopile to save
battery
•
6-hour Automatic Shut Down Option
•
Convenient NG/LP Gas Type Conversion
•
Standing Pilot/Intermittent pilot Conversion
•
Previous settings Restoration Ability (Memory Off)
•
Uninterrupted Operation During Power Outage (Auto-
matic Battery Backup)
•
ON/OFF RF Remote Receiver
•
Optional Transmitter Learn Capability
AC module Board (Requires tsFRsC Remote)
•
Easy Snap-on Design
•
Embedded Compact 120 VAC Adapter with Auto Battery Back up Feature
•
Remote Controlled 3-step Blower, Lighting, and On/Off Auxiliary AC Outputs
transmitter (Optional)
Three Flame Height Settings
Low battery Indication for Transmitter
Child Proof Lock-out
LCD Backlight
Security Codes 16
Countdown 6 hr Timer
Standard Thermostatic Control Mode
Smart Mode ® Thermostat
Three Brightness Settings for Lights
Three Speed Control for Blower
On/Off AUX Rear Burner
Programmable Timer to turn blower on and off
BAtteRy INstAllAtION
The Command Center uses four (4) "AA" batteries as back up for power outages. The system can oper-
ate for approximately six (6) months on battery power.
to Install Batteries (not included):
1. Press down the battery door tabs and pull out to remove battery door.
2. Install the batteries as indicated on Command Center.
3. Close battery door by snapping in place.
4. When the four (4) batteries are installed the system will operate without power.
5. The batteries should be replaced when the LED indicates low battery or at least once a year.
20304166
(Auto Flame & Blower Modulation)
VC31LDVI/VC31CDVI Gas Fireplace Insert
RF Receiver
ON/OFF
NG/LP
Conversion
Control
Board
ON
LED
OFF
Battery Door
Figure 33 -
Signature Command System Components
FP1917
Signature components
TSFRSC
8/08
X
X
X
X
X
X
X
X
X
X
X
X
To Thermopile
To Sensor
To Sparker
To Command Center
To Stepper Motor
To Valve
Master Switch
AC Module
Command
Center
29