Table of Contents
Advertisement
1.
Attach the Nailer/Stapler to the air supply at the Air Inlet Plug (78). Start your com-
pressor and check the pressure, making sure it is set no higher than 125 PSI.
Do not exceed the maximum 125 PSI.
2.
Rotate the Air Deflector (3) so that the exhaust air blast will be directed away from
the operator.
3.
To fire, place the Driver Guide (62) of the tool on the workpiece. The Nailer/Stapler
should not fire if the Driver Guide is not depressed. Once depressed, gently and
briefly squeeze the Trigger (32) once; one Brad/Staple will be fired.
4.
Allow the tool to do the work. Tool should be held firmly against work surface, or
the fastener may not be driven deeply enough. Always allow the tool to recoil off
the work surface. Be careful not to nail or staple over another nail or staple.
AIR DEFLECTOR (3)
DRIVER GUIDE (62)
5.
When finished using the Nailer/Stapler, always disconnect the tool from its air sup-
ply. Empty the Movable Magazine (61) completely of Brads/Staples. Attempt to fire
the tool into a piece of scrap wood to ensure it is disconnected and is incapable of
firing any Brads/Staples.
6.
Make sure to store the Nailer/Stapler in a clean, dry, safe location out of reach of
children.
For technical questions, please call 1-800-444-3353
SKU 95218
OPERATING THE NAILER/STAPLER
MOVEABLE MAGAZINE (61)
AIR INLET PLUG
(78)
TRIGGER
(32)
FIXED LEVER (53)
PAGE 8
Advertisement
Table of Contents
