Table of Contents
Advertisement
Do not operate tool if under the influence of alcohol or drugs. Read warning
16.
labels if taking prescription medicine to determine if your judgement or reflexes are
impaired while taking drugs. If there is any doubt, do not operate the tool.
Use proper size and type extension cord for an air compressor. If an exten-
17.
sion cord is required, it must be of the proper size and type to supply the correct
current to the compressor without heating up. Otherwise, the extension cord could
melt and catch fire, or cause electrical damage to the compressor. Check your air
compressor's manual for the appropriate size cord. It is also possible that the use
of an extension cord may cause your circuit breaker to trip or your panel fuse to
break. If this happens, either use the compressor without an extension cord or find
a larger amperage circuit to use.
18.
Maintenance. The maintenance outlined in the "Maintenance" section should be
performed regularly. For your safety, this product should be serviced or repaired
regularly only by a qualified technician.
Compressed air only. Use clean, dry, regulated, compressed air at between 90
19.
and 125 PSI. Never use oxygen, carbon dioxide, combustible gases, or any other
bottled gases a power source for this tool.
Do not load brads or staples with the trigger or safety depressed. Uninten-
20.
tional firing may occur. Do not load brads when the air hose is connected to the
tool. Always assume the tool contains brads or staples.
Disconnect air supply before loading this tool. Before reloading (or making any
21.
adjustments to) the tool, make sure the compressed air is disconnected.
Fire brads and staples into an appropriate work surface only. Do not attempt
22.
to fire brads or staples into surfaces too hard to penetrate. Do not drive brads or
staples on top of other brads or staples, or at too steep an angle. Brads and staples
can ricochet, causing personal injury. Never fire this tool into the air, or point it toward
yourself or another person. Always wear ANSI-approved impact safety goggles
during use, maintenance, and reloading.
Do not fire brads or staples too close to the edge of a workpiece.
23.
They may split the workpiece and fly free, causing personal injury.
Take caution, as some woods contain preservatives such as copper
24.
chromium arsenate (CCA) which can be toxic. When nailing these materials
extra care should be taken to avoid inhalation and minimize skin contact.
WARNING: Some dust created by power sanding, sawing, grinding, drilling,
25.
and other construction activities, contains chemicals known [to the State of
California] to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
Lead from lead-based paints
For technical questions, please call 1-800-444-3353
SKU 95218
PAGE 4
Advertisement
Table of Contents
