Surround Assembly - Jøtul C 350 Installation And Operating Instructions Manual

Figure 12.
Surround Panel assembly viewed
from backside.
Tools Required:
• 10 mm socket or wrench
Trim Mounting
Bracket Plate
Figure 14. Bottom Surround Trim assembly.

Surround Assembly

All fasteners have already been installed in the ap-
propriate locations at the factory. You will need to
remove them, attach the parts together as described
below and reinstall the fasteners at those locations.
1. Layout the parts. Place the castings face down on
a protective surface such as carpeting, blankets or
a sheet of cardboard.
2. Attach the Breastplates to each other.
Use a 10 mm socket or wrench with two M6 x 10
hex head flange bolts. Adjust the set screw to
obtain parallel alignment of the two plates.
3. Attach the Leg plates. The Legs must be oriented
with the Hang Tabs on the inside edges as shown
in
fig. 12. Use the two remaining M6 x 12 hex head
flange bolts to attach the Legs to the Breastplate
assembly.
4. If the Riser Bar is used, attach the two Bottom
Surround Trim panels together with the single
M6 x 10 hex bolt. Attach the Trim Mounting Brack-
et to the back of the Bottom Trim assembly using
the other two M6 x 10 bolts. Be sure to orient the
bracket as shown in fig. 14.
M6 x 10
Set Screw
Right Breastplate
Hang Tabs
Right Bottom Trim
Jøtul C 350 Winterport 138376_Rev_H 8.2.10
Left Breastplate
Right Leg
All fasteners are M6 x
10 mm hex head bolts,
pre-installed.
Left Bottom Trim
Tighten just snug enough to allow for final adjust-
ment when the Surround assembly is attached to
the firebox.
Bend the perforated mounting plate down 90°
as shown in Fig 14. Insert and center the bracket
plate sandwiched between the firebox and the
Riser Bar.
5. If appropriate, attach the Extended Surround
Panel to the firebox. With the painted side facing
out, engage the hooked tabs on panel with the
slots in the backside of the Surround Brackets on
the firebox. Extend the blower power cord out
beyond the surround panel.
6. Attach the Assembly to the Firebox. Lift the entire
assembly upright and position it in front of the
insert firebox. The four Hang Tabs on the surround
legs must engage with the adjacent cutouts in the
two brackets on either side of the firebox opening.
The surround will easily engage with these brack-
ets if the firebox is slightly proud of the fireplace
opening.
Hang the surround assembly on the firebox and
push the entire unit into position so that the sur-
round is flush against the fireplace face.
Hang Tabs
Left Leg
13