Table of Contents
Advertisement
Installation
Preparation of chassis
CAUTION: To avoid the
possibiity of personal injury,
unplug power to unit before
installing or servicing.
Pick a location which will allow you to blow the cold
air into the area you want. Windows used for
installation must be strong enough to support the
weight of the air conditioner. Good installation with
special attention to the proper position of the unit will
lessen the chance that service will be needed.
When cooling more than one room, installation
location is very important. To cool your rooms, cold
air must be blown from the air conditioner in a
straight path.
How to Install
If the air conditioner is blocked by a storm window
frame, see step 13 on page 14 before beginning to
install.
1. Cut the FOAM STRIP (ITEM G) to fit the
underside of the window sash. Open the window,
peel off the FOAM STRIP backing and attach the
FOAM STRIP as shown in FIG. 1.
@@
@@
FOAM STRIP
(ITEM G)
2. Mark center line with pencil on the center of the
inner sill, as shown in FIG. 2.
INDOOR
CENTER LINE
12 Room Air Conditioner
FIG. 1
INNER SILL
FIG. 2
3. Install support bracket on window. See FIG. 3.
Install leveling bolt up through bottom side of
support bracket. You can choose a short bolt
(ITEM C) or a long one (ITEM B) according to
window type. Also, you should select the position
of hole on bracket.
Position bracket on sill on the center line of
window (See FIG. 3).
Fasten bracket loosely to sill with screws (ITEM D)
provided.
Adjust leveling bolt so that the air conditioner will
be installed with a very slight tilt (about 1/4")
downward toward the outside for proper drainage.
Tighten bracket screws.
OUTER
WINDOW
SILL
SCREW
SCREW
(ITEM D)
(ITEM D)
INNER
WINDOW
SILL
CENTER LINE
CENTER LINE
OF WINDOW
OF WINDOW
SCREW
INNER SILL
INDOOR
CAUTION: During the following
step, hold unit firmly until window
sash is lowered to top channel
behind curtain frames. Personal
injury or property damage may
result if unit falls from window.
CLOSE-UP VIEW
CLOSE-UP VIEW
OF SUPPORT BRACKET
OF SUPPORT BRACKET
(ITEM A)
(ITEM A)
ADJUSTMENT SLOT
LEVELING BOLT
LEVELING BOLT
(ITEM B or C)
(ITEM B or C)
FIG. 3
SUPPORT
BRACKET
ABOUT 1/4"
LEVELING
BOLT
OUTER SILL
OUTDOOR
FIG. 4
Advertisement
Table of Contents
