Table of Contents
Advertisement
Installation
4. If AIR CONDITIONER is Blocked by Storm
Window FRAME
• If storm window presents interference, fasten a
2" wide wood strip to the inner window sill across
the full width of the sill. The wood strip should be
thick enough to raise the height of the window sill
so that the unit can be installed without
interference from the the storm window frame.
See FIG. 9.
Top of wood strip should be approximately 3/4"
higher than the storm window frame to help
condensation to drain properly to the outside.
• Install a second wood strip (approximately 6"
long by 11/2" wide and same thickness as first
strip) in the center of the outer sill flush against
the back of the inner sill.
WOOD STRIP
MOUNTED ON TOP
OF INNER SILL
INNER
SILL
WOOD STRIP
WOOD STRIP
FOR SUPPORT
FOR SUPPORT
BRACKET
BRACKET
INDOOR
When storm window
frame is located on outer sill
REMOVAL FROM WINDOW
• Turn off and unplug the air conditioner.
• Unscrew the side screws that you installed in
Step 2(Page 13).
• Close the curtain frame and remove foam seal and
L bracket from the windows.
• Keep a firm grip on the air conditioner and raise the
sash.
• Lift the air conditioner from the window.
• Remove the foam strip from between the window.
• Remove the support bracket from window frame.
• Place unit and mounting hardware in air conditioner
shipping carton, and store in clean, dry place.
14 Room Air Conditioner
1 1/2" min.
3/4"(19mm)
(38mm)
CLEARANCE
STORM
WINDOW
FRAME
OUTER
SILL
OUTDOOR
FIG. 9
CAUTION:
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
Advertisement
Table of Contents
