Table of Contents
Advertisement
Operating Instructions
POWER
• To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again.
This button takes priority over any other button.
When you first turn it on, the air conditioner is on the High cool mode and the Temp. at 72°F
AIR PURIFIER
• Press the Air Purifier button.
Operation will start when the button is pressed and stop when the button is pressed again.
• You can select the fan speed in three settings: High, Low or Medium.
Each time the button is pressed, the fan speed mode is shifted.
• If you press only the Air Purifier button, only air purifying operates without cooling.
You can select the fan speed in three settings: High, Low or Medium.
Each time the fan speed button is pressed, the fan speed mode is shifted.
TEMPERATURE/TIME CONTROL
• The thermostat monitors room temperature to maintain the desired temperature.
The thermostat can be set between 60°F~86°F (16°C~30°C).
• This button also controls the timer setting in TIMER mode. The timer can be set up to 24 hours.
FAN SPEED
• For increased power while cooling, select a higher fan speed.
3 steps: High ¡ Low ¡ Medium ¡ High ...
SLEEP
• Press the sleep mode button to set the time you want the unit to turn off automatically.
• Press this button to increase the hours until shut off from 1 through 7 hours.
• For your sleeping comfort, once Time is set, the Temperature setting will raise 2˚F after 30 min.,
and 2°F after another 30 min.
TIMER
- SHUT-OFF TIME
• You will usally use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• You can control your timer setting up and down with TEMP/TIME button.
- START TIME
• If unit is off, use Timer to set number of hours before unit starts.
• You can control your timer setting up and down with TEMP/TIME button.
MODE
- Push this botton to shift MODE of operation from COOL ¡ ENERGY SAVER ¡ FAN ¡ DEHUMIDIFY.
- ENERGY SAVER
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and check the room air to determine if cooling is needed.
How to Insert Batteries into Remote Control
1. Remove the cover from the back of the
remote control.
• Open the cover according to the arrow
direction on the cover.
2. Insert two batteries.
• Be sure that the (+) and (-) directions are
correct.
• Be sure that both batteries are new.
3. Re-attach the cover.
16 Room Air Conditioner
• Do not use rechargeable batteries.
Such batteries differ from standard dry cells in
shape, dimensions, and performance.
• Remove the batteries from the remote
controller if the air conditioner is not going to
be used for an extended length of time.
• You can put the remote control holder on the
place of your preference with two screws
enclosed in vinyl bag.
AIR
PURIFIER
AIR
PURIFIER
POWER
TEMP/TIME
FAN SPEED
SLEEP
MODE
TIMER
Advertisement
Table of Contents
