Operating Instructions - LG LA1000PR Owner's Manual

Operating Instructions

Remote Control Operation
CAUTION: If you turn off the air conditioner or switch from cooling to
the fan, wait at least 3 minutes before setting to cooling again.
CONTROL PANEL DISPLAY
TEMPERATURE/TIME CONTROL
• The thermostat monitors room temperature to maintain
the desired temperature. The thermostat can be set
between 60°F~86°F (16°C~30°C).
• This button also controls the timer setting in TIMER
mode. The timer can be set up to 24 hours.
DEHUMIDIFY
• Press this button for Dehumidify Function.
• Dehumidify Function Allows for moisture removal
without decreasing room temperature.
TEMP/TIME
AIR PURIFIER
• Press the AIR PURIFIER button.
Operation will start when the button is pressed and stop when
the button is pressed again.
• You can select the fan speed in three settings:
High, Low or Medium.
Each time the button is pressed, the fan speed mode is shifted.
• If you press only the AIR PURIFIER button, only air purifying
operates without cooling.
You can select the fan speed in three settings:
High, Low or Medium.
Each time the fan speed button is pressed, the fan speed mode
is shifted.
FAN SPEED
For increased power while cooling, select a higher fan speed.
3 steps: High ¡ Low ¡ Medium ¡ High ...
SLEEP
• Press the sleep mode button to set the time you want the unit to turn off automatically.
• Press this button to increase the hours until shut off from 1 through 7 hours.
• For your sleeping comfort, once Time is set, the Temperature setting will raise 2˚F after 30 min., and 2°F after another 30 min.
Opening the Panel Door
You can open and shut the Panel
Door both by your fingertips and by
Remote Control.
DEHUMIDIFY FAN
FAN
AIR PURIFIER
SPEED
FAN
Press this button for basic ventilating fan operation.
ENERGY SAVER
The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and check
the room air to determine if cooling is needed.
COOL
Press this button for cooling operation.
REMOTE CONTROL SIGNAL RECEIVER
ENERGY
COOL
SAVER
SLEEP TIMER
POWER
Operation starts when this button is pressed and stops when you
press the button again.
- AUTO RESTART
In the event of a power failure, the unit will run at the previous
setting once power returns.
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• You can control your timer setting up and down with TEMP/TIME
button.
- START TIME
• If unit is off, use Timer to set number of hours before unit starts.
• You can control your timer setting up and down with TEMP/TIME
button.
Operating Instructions
POWER
Owner's Manual 15