Troubleshooting - Ryobi RLT-1000EX Operator's Manual

PROBLEM
Line will not advance when
tapping bump button
Bump head is hard to turn
Grass wraps around the
attachment shaft and the
trimmer head assembly
Liner trimmer stops and will
not start again

TROUBLESHOOTING

POSSIBLE CAUSE
1. Line is welded to itself.
2. Not enough line on spool.
3. Line is worn too short.
4. Line is tangled on spool.
Grass wrapped or built up
around head.
Cutting tall grass at ground level.
1) Overload protection activated
2) Fuse from main supply blown
3) Unit failed
Waste electrical products should not be disposed of together with household waste. Please
recycle where facilities exist. Check with your local authority or retailer for recycling advice.
ENGLISH
DIPOSAL
DISPOSAL
9
SOLUTION
1. Lubricate with a silicone spray.
2. Install more line (Refer to "Replacing
replacement spool" earlier in this
manual).
3. Pull lines while alternately pressing down
on and releasing bump button.
Clean affected parts of the machine.
Cut tall grass from the top down.
1) Wait 10 minutes before restarting
2) Check fuse
3) Contact dealer to check damage