Troubleshooting - Ryobi RLTGM25CS Operator's Manual

PROBLEM
Engine will not start.
Engine does not reach full speed
and emits excessive smoke.
Cutting line will not advance when
using bump feed action.
Grass wraps around the trimmer
head assembly and the attachment
shaft.
Oil drips from muffler.
English (Original Instructions)
TROUBLE SHOOTING
POSSIBLE CAUSE
1. Switch set to the O (OFF) position.
2. No spark.
3. No fuel.
4. Flooded engine.
5. Starter cord is hard to pull.
1. Check oil fuel mixture.
2. Air filter is dirty.
3. Spark arrestor screen is dirty.
1. Line welded to itself.
2. Not enough line on the spool.
3. Line worn too short.
4. Line tangled on spool.
5. Engine speed too slow.
6. Line spool installed back to front.
1. Cutting tall grass at ground level.
2. Operating the product
throttle.
1. Operating the product
throttle.
2. Check oil/fuel mixture.
3. Air filter is dirty.
1. Set switch to the I (ON) position.
2. Remove the spark plug. Reattach the spark plug cap
and lay the spark plug on the metal cylinder. Pull
the starter cord and watch for a spark at the spark
plug tip. If there is no spark, repeat the test with a
new spark plug.
3. Push primer bulb until the bulb is full of fuel. If the
bulb does not fill, the primary fuel delivery system
is blocked. If the primer bulb fills, the engine may
be flooded. (See next item.)
4. Remove the spark plug. Turn the product so that
the spark plug hole is aimed at the ground. Make
sure the choke lever is set to position B and pull
the starter cord 10 to 14 times. This clears excess
fuel from the engine. Clean and reinstall the spark
plug. With the throttle trigger fully depressed, pull
the starter cord 3 times. If the engine does not start,
set the choke lever to A and follow normal starting
instructions. If the engine still fails to start, repeat
the procedure with a new spark plug.
5. Contact an authorized service dealer.
1. Use fresh fuel and the correct 2-stroke oil mix.
2. Clean the air filter according to the instructions in
the Maintenance section.
3. Contact an authorized service dealer.
1. Lubricate with silicone spray.
2. Install more line.
3. Pull line while alternately pressing down on and
releasing the retaining cap.
4. Remove line from spool and rewind.
5. Advance line at full throttle.
6. Ensure the writing on the line spool is facing the
correct way; THIS SIDE OUT FOR CURVED
SHAFT.
1. Cut tall grass from the top down.
at part
2. Operate the product at full throttle.
at part
1. Operate the product at full throttle.
2. Use fresh fuel and the correct 2-stroke oil mix.
3. Clean the air filter according to the instructions in
the Maintenance section.
9
SOLUTION