Viii, Troubleshooting Chart - Ryobi 700r Operator's Manual

. .v.....,
Engine will not start
Fouled spark plug
Engine will not Idle
Engine will not accelerate
Engine lacks power or
stalls when cutting
String head will not
advance line
"TI
Ignition switch is "OFF"
Empt_ fuet tank
Primer bulb wasn't pressed
enough
Engine flooded
Old or lmimx_perlyMixed Fuel
Excessive oil in oil / fuel
mlxtam or Old Fuel
carburetor mleadjeated
Old or ImpmpeHy Mixed Fuel
Old or Improperly Mixed Fuel
String head bound with grass
Muffler plugged
Throttle wlm has come loose
Dirty air filter
No ell in fuel or Old Fuel
Carburetor minedjustad
Muffler plugged
String head bound with grass
String head out of line
inner reel bound up
String head dirty
Line welded
Line twisted when refilled
Not enough line is exposed
l'lli'll
Turn swltdil to "ON"
Fill fuel tank
Pines primer bulb fully and slowly
5-7 times
Use starting procedure WITHOUT
USING CHOKE
Drain fuel tank / Add fresh fuel
mlxtum
Replace spark plug / Drain fuel
tank / Add freah fuel mixture
Adjust _mtor
Drain fuel tank / Add fresh fuel
mixtum
Drain fuel tank / Add fresh fuel
mixture
Stop engine and clean string head
Clean or replace muffler
Tighten thmtfie wire
Clean or replace air filter
Drain fuel tank / Add fresh fuel
mixture
Adjust carburetor
Clean or mplaea muffler
Stop engine and clean string head
Refill with new line
Replace Inner reel
Clean inner reel and outer spool
Olsassemble, remove the welded
eactlen and rewind the line
Disassemble and rewind line
Push the Bump Knob and pull out
line until 4 Inches (102 ram) of line
is outside of the string head
If further assistance ts required, contact your authorized service dealer.
18