Bosch IUI-MAP0001 User Manual page 41

MAP Control Center
View History
On the Event History screen, press the View History button. The View History screen
(Figure 2.68, Page 41) opens with a list of the events stored in the control panel's history
memory. These events are not limited to events initiated by the system's sensors. All system
activity, such as arming and disarming the system, system troubles, system tampers, and so
on are listed on the View History screen.
The default history filter is the last 24 hours. To expand the time range, select Filter by Date
Range (refer to Section Filter By Date Range, page 41).
To view only sensor events, refer to Section 2.10 Event Memory, page 55.
Figure 2.68 View History screen
Print History
On the Event History screen (Figure 2.66, Page 40), press Print History. The system prints
the history data using the system printer. The control center display shows the message:
Attention - Request to: Print History Succeeded (Figure 2.69, Page 41) or The printer is not
ready.
Figure 2.69 Print History Succeeded screen
Filter By Date Range
On the Event History screen (Figure 2.66, Page 40), press Filter By Date Range. The Filter:
Event History Dates screen (Figure 2.70, Page 42) opens. Press Beginning Date or Ending
Date, then touch the date and time buttons to select the element to change. Press the + and -
buttons to change the dates in the range.
Bosch Security Systems, Inc. User guide
Operation | en 41
F.01U.168.328 | 03 | 2011.05