Programming Memory Locations - Cobra Micro Talk 3 Operating Instructions Manual

FRS300.MANUAL.qx 10/2/98 12:39 PM Page 28
Advanced Features
Programming

Programming Memory Locations

Memory
Your MicroTalk 3 has 10 memory (0-9) lo cations
Locations for storing your most frequently used channels.
1 Rotate ON - OFF Volume Control clockwise.
An audible "tone" will indicate the unit is on
and then the LCD will go through a 3 second
self-test and then go to operational mode.
2 Push and release button until
MEM
Function
a memory location flashes.
3 Select memory location you wish to change by
pushing and releasing buttons (Use
Channel
MEM 6 for this example).
22
Advanced Features
4 Push and release button again.
Function
MAIN CHANNEL will flash and only the
MEM
icon will remain flashing.
icon and
5 Select desired main channel you wish to store
(1-14) by pushing and releasing
Channel
buttons. (Use CHANNEL 12 for this example.)
continued
23
Note
Once you enter memory
mode you can talk and listen
to any channel you select
after programming is
complete. See Using Memory
Locations section on
page 26.