Programming Memory Locations - Cobra microTALK PR 1050 WX Operating Instructions Manual

O P E R AT I O N
Programming Memory
Locations
Your microTALK ® radio has 10 memory
locations (1-10) for storing your most
frequently used channels and privacy codes.
To program locations:
1. Push the MODE
button until the
MODE
Memory icon and
button
the memory
location flashes.
2. Select the memory
CHANNEL SELECT
location you wish
button
to change by
pushing the
CHANNEL SELECT
button up or down. (NOTE: You must
press the channel button before
programming a memory location.)
3. Press and release the MODE button again.
The Memory icon and the main channel
number will flash.
4. Select the main channel you wish to store
by pushing the CHANNEL SELECT button up
or down.
9
ENGLISH
5. Press the MODE
button again to
store the main
channel in memory
and move to
privacy code selection. The privacy code
number begins flashing and the Memory
icon continues to flash.
6. Select the privacy code (00-38) you
wish to store by pushing the CHANNEL
SELECT button up or down.
7. Press the ENTER
button to program
TALK button
your selection. You
may also press the
TALK button to
transmit your selected channel and
privacy code, which will be stored into
the memory location you are using.
(NOTE: To "unprogram" a memory
location you programmed previously,
select 00 for both the main channel and
privacy code in steps 4 through 6.)
8. Press and release the ENTER button to
return to Standby mode at your new
memory location, or press and release
the MODE button
MODE ENTER
to save the
button button
memory location
and proceed to
other functions.
ENGLISH
Recalling Memory Locations
To recall a channel you have stored in a
memory location:
1. Press the MODE
button until the
MODE
Memory icon and
button
a memory
location flashes.
2. Select your
CHANNEL SELECT
desired memory
button
location by
pushing the
CHANNEL SELECT
button up or
ENTER
down. Press the
button
ENTER button
to select your
memory location
channel. You will
now be in Standby Mode on that channel.
3. Repeat steps 1 and 2 to recall other
memory locations.
Using the Scan Function
Your microTALK ® radio can automatically
scan main channels (1-22), the privacy
codes (00-38) within one main channel,
or memory locations.
O P E R AT I O N
To scan main channels:
1. Press the MODE button until the Scan icon
and main channel number flashes.
2. Push the CHANNEL SELECT button up or
down and the unit will begin scanning the
main channels. (NOTE: The unit "ignores"
privacy codes while scanning main channels.)
3. The radio will continue to scan all main
channels and stop if an incoming
transmission is detected. The unit will
remain on that channel for 10 seconds.
During that time you can:
a) Press and hold
the TALK button
TALK button
and talk. The radio
will remain on that
channel and return
to Standby mode.
b) Push the CHANNEL SELECT button up or
down to resume scanning main channels.
c) Press the MODE button to proceed to
privacy code scanning (see following page).
If you do not press any button within
10 seconds, the radio will automatically
resume scanning main channels.
10