Power On - SOYO SY-K7AIA User Manual

Hardware Installation
This motherboard requires a power supply, that meets the ATX 2.03
specifications. Make sure the power supply can support at least 720mA on
the 5V Standby lead.
Please install the ATX power according to the following pin assignment:
ATX Power
12V
5VSB
PW-OK
GND
5V
GND
5V
GND
3.3V
3.3V

2-3.4 Power On

You have now completed the hardware installation of your Motherboard
successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the system
is performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and press
<DEL> key again at the beginning of boot-up, during diagnostic
checks.
5V
5V
-5V
GND
Ø
GND Pay special care to the directionality.
GND
PS-ON
GND
-12V
3.3V
42
SY-K7AIA