Britax Max-Way User Manual page 30

2. Installing your child seat (rearward facing) in rear side seat
IMPORTANT
2a
diagonal seat belt.
The child seat has an adjustable support leg
more reclined the seat must be.
The larger the child the more upright the seat must be. To change the position
2b
(if required) slide the support leg out until it engages in the desired position.
To slide the support leg in push the two support leg adjuster buttons and pull
up the support leg
Place the child seat rearward facing on the car seat. After installation the gap
2c
between the seat in front and child seat should be a minimum of 10mm.
It must NOT
without making the driver or passenger sit in an uncomfortable position. If not
try another seating position in the car
Extend the footprop fully by pressing the two release Buttons. Make sure
that the footprop tether brackets are facing forwards and that the straps
are not twisted. Lower the footprop and adjust the height so that it is within
approximately 30mm of the floor
page of this manual to get the correct distance from the footprop to the floor.
2d 2e
2
– The child seat can be used with either a lap or a lap and
(dia 2a). The smaller the child the
(dia 2b). Make sure the support leg is engaged firmly.
rest against the car seat. If it does then adjust the car seat in front
(dia 2c).
(dia 2c). Use the ruler printed on the back
Slide the loop ends of the tether straps
between the front car seat and back as
shown (dia 2d &
hook ends of the tether straps around
the outside of the car seat and feed
through the loops 2
3
of the tether straps onto the fixing rings
on the back of the child seat
Provisionally tighten the tether straps by
pulling the loose ends downwards
4
2f
2g
2h
2j
dia 2e). Bring the
. Snap the hooks
.
3
.
4
Slide the loop ends of the tether straps between the front car seat and back
as shown (dia 2d & dia 2e). Bring the buckle ends of the tether straps
around the outside of the car seat and feed through the loops
snap hooks of the tether straps into the metal loops on back of the seat.
Provisionally tighten the tether straps by pulling the loose ends downwards.
Pull off sufficient lap and diagonal belt (approx.600 –
off arm on the side opposite the seat belt buckle. Pull back the child seat cover
to reveal the crotch strap. Feed the belt through the lock-off belt guide and seat
(dia 2g), up on to the top face of the seat base, behind the crotch
shell slot
strap (inset) and down through the slot on the other side of the child seat.
Open the other lock-off arm, feed the seat belt under the lock-off arm and
(dia 2h).
attach the tongue into the buckle
Pull all of the seat belt slack through the
2i
child seat ensuring the seat belt is not
twisted (dia
as possible, close the lock-off arms on
BOTH sides of the seat ensuring that they
click into place.
If the buckle now lies in the position
marked as wrong with a
belt cannot be correctly tightened
try another seating position in the car.
Finally tighten the tether straps by pulling
the loose ends downwards
until the footprop touches the floor. The
2k
footprop must rest on a solid floor – not
on lids of storage boxes or similar.
Once firmly strapped in, test the child seat
by trying to move it back and forth and
side to side. If it seems loose, you must
re­install until firmly installed.
DO NOT
against the driver or front passenger
seats.
9-25 kg
2
. Click the
900mm). Open the lock-
2i). When the belt is as tight
and the seat
(dia 2j),
(dia 2k)
rest the back of the child seat