Britax Max-Way User Manual page 27

Important!
GB
9-25kgs Group 1-2 (approximate age 9 months – 6 years)
You must ensure that you follow these instructions
carefully and correctly. If this seat is not fitted securely and
your child is not strapped in correctly, your child and other
passengers are at serious risk of injury in the event of an
accident
Please read this User Guide carefully BEFORE
trying to install your child car seat.
Britax advise that child car seats should
not be bought or sold second-hand. Please
dispose of your child seat safely. Do not sell or
pass it on.
After an accident, the child seat and your car
seat belts should be replaced. Although they
may look undamaged, if you were to have
another accident the child seat and your car
seat belts may not be able to protect your child
as well as they should.
No child seat is escape proof
Harness systems cannot be designed to be
completely "child proof" and yet comply with
the legal requirements of European Standard
ECE R44. The harness must be fastened and
adjusted correctly at all times and children
encouraged to remain within the harness
system.
Looking after your child seat
Food and drink may find their way inside the
buckle of the harness. This can stop it from
working properly – it will not click. Wash in
warm water until clean (dia A and B).
Cleaning the cover
Please read the labels on the cover for
washing instructions.
DO NOT tumble dry the cover – short spin and
drip dry only.
Cleaning the harness and seat shell
Sponge clean ONLY using hand soap and
warm water.
DO NOT take apart, or attempt to take apart,
any part of the harness or seat when cleaning.
DO NOT use solvents, detergents or washing-
up liquid as these may weaken the harness
and the seat.
DO NOT lubricate or oil any part of the seat.
Removing and refitting the cover
Press in and hold the harness release button
and with your hand below the chest pads
(dia 1a) pull BOTH shoulder straps forwards
as far as they will go. Release the harness
buckle (press the red release button).
Remove the headrest cover.
Undo the Velcro fastner on the crotch cushion
and remove it. Open the snaps and the Velcro
fastners at the left and right on the back part of
the cover.Thread the harness straps through
the recesses in the cover.Unhook the cover
from under the edge of the seat shell.
Pull cover up over the bevel, buckle and
headrest from bottom to top.
To refit the cover, simply proceed in the
reverse order from removal.
Make sure the straps are not twisted.
IMPORTANT
– The cover and shoulder pads
are a safety feature. NEVER use the child
seat without them. Don't put your child's safety
at risk by using other makes of replacement
cover, they could stop the child seat from
protecting your child as well as it should.
A replacement cover is available from your
Britax stockist or contact Britax Customer
Service Department on +46 8564 841 00.
Guarantee
All Britax products are carefully designed,
manufactured and tested. However, should
this product prove faulty within 24 months of
purchase due to a materials or manufacturing
fault please return it to the original place of
purchase. We will then, at our discretion, either
repair it free of charge or replace it with the
same or a similar product.
For guarantee purposes proof of purchase will
be required. We recommend that you retain
your receipt and attach it to this user guide and
store in the seat.
Britax does not accept liability for damage
arising from abuse, misuse or negligence.
This guarantee is not transferable and
therefore does not apply to second-hand
products.
Your statutory rights are not affected by this
guarantee.
9-25 kg 9-25 kg
If in doubt
Not all car seats fit all cars. For advice as
to the suitability of this restraint for your car
please use on our website at www.britax.eu,
call our Customer Service Helpline on
+46 8564 841 00 or email
helpline@uk.britaxeurope.com.
A
B