HP ProCurve 6200yl Multicast And Routing Manual page 80

PIM-DM (Dense Mode)
Displaying PIM Data and Configuration Settings
ProCurve(config)# show ip pim interface 29
PIM Interface
VLAN : 29
IP Address : 10.29.30.1
Mode : dense
Hello Interval (sec)
Hello Delay (sec)
Graft Retry Interval(sec) : 3
Max Graft Retries
Override Interval (msec)
Propagation Delay (msec)
SR TTL Threshold
Figure 3-12. Example Output for Routing Switch "#1" in Figure 3-4 on Page 3-20
3-30
Syntax: show ip pim [interface [< vid >]]
Displays the current configuration for the specified VLAN
(PIM interface). Refer to table 3-1, below.
: 30
: 5
: 2
: 2500
: 500
: 2
Table 3-1. PIM Interface Configuration Settings
Field Default Control Command
VLAN n/a
IP n/a
Mode dense
Hello Interval (sec) 30
Hello Hold Time 105
Hello Delay 5
Graft Retry Interval 3
(sec)
Max Graft Retries 2
Lan Prune Delay
Lan Delay Enabled
State Refresh Capable
vlan < vid > ip pim-dense
vlan < vid > ip pim-dense < any | ip-addr >
PIM-Dense or PIM-Sparse
ip pim-dense hello interval < 5 - 30 >
The routing switch computes this value from the current "Hello
Interval" and includes it in the "Hello" packets the routing
switch sends to neighbor routers. Neighbor routers use this
value to determine how long to wait for another Hello packet
from the routing switch. Refer to the description of the Hello
Interval on page 3-15.
vlan < vid > ip pim-dense hello delay < 0 - 5 >
vlan < vid > ip pim-dense graft-retry-interval < 1 - 10 >
vlan < vid > ip pim-dense graft-retries < 1 - 10 >
: Yes
: No
: No