Introduction - HP ProCurve 6200yl Multicast And Routing Manual

Procurve series switch
Hide thumbs Also See for ProCurve 6200yl:
Table of Contents

Advertisement

Introduction

Feature
Configure PIM Global
Configure PIM VLAN Interface
Display PIM Route Data
Display PIM Status
In a network where IP multicast traffic is transmitted for multimedia applica­
tions, such traffic is blocked at routed interface (VLAN) boundaries unless a
multicast routing protocol is running. Protocol Independent Multicast (PIM)
is a family of routing protocols that form multicast trees to forward traffic
from multicast sources to subnets that have used a protocol such as IGMP to
request the traffic. PIM relies on the unicast routing tables created by any of
several unicast routing protocols to identify the path back to a multicast
source (reverse path forwarding, or RPF). With this information, PIM sets up
the distribution tree for the multicast traffic. The PIM-DM and PIM-SM proto­
cols on the switches covered by this manual enable and control multicast
traffic routing.
IGMP provides the multicast traffic link between a host and a multicast router
running PIM-DM or PIM-SM. IGMP and either PIM-DM or PIM-SM must be
enabled on VLANs whose member ports have directly connected hosts with
a valid need to join multicast groups.
PIM-DM is used in networks where, at any given time, multicast group mem­
bers exist in relatively large numbers and are present in most subnets. PIM­
SM (described in chapter 4 of this guide) is used in networks where multicast
sources and group members are sparsely distributed over a wide area and can
result in unnecessary multicast traffic on routers outside the distribution
paths needed for traffic between a given multicast source and the hosts
belonging to the multicast group. In such networks, PIM-SM can be used to
reduce the effect of multicast traffic flows in network areas where they are
not needed. And because PIM-SM does not automatically flood traffic, it is a
logical choice in lower bandwidth situations such as WAN environments.
Default
Menu
n/a
n/a
Disabled
0 (Forward All)
PIM-DM (Dense Mode)

Introduction

CLI
Web
3-12
3-15
3-23
3-28
3-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 5400zlProcurve 3500yl

Table of Contents