HP ProCurve 6200yl Multicast And Routing Manual page 64

PIM-DM (Dense Mode)
Configuring PIM-DM
To configure global-level PIM operation for the "5400zl #1" routing switch, you would use the
commands shown in figure 3-3, below.
ProCurve(config)# ip routing
ProCurve(config)# ip multicast-routing
ProCurve(config)# router rip
ProCurve(rip)# exit
ProCurve(config)# router pim
ProCurve(pim)# state-refresh 45
ProCurve(pim)# trap hardware-mrt-full
ProCurve(pim)# write mem
ProCurve(pim)# exit
Using show run displays the configuration changes
resulting from the above commands.
ProCurve(config)# show run
Running configuration:
; J8697A Configuration Editor; Created on release #K.11.XX
hostname "ProCurve"
module 1 type J8702A
module 2 type J8702A
ip routing
snmp-server community "public" Unrestricted
vlan 1
.
.
.
vlan 29
.
.
.
vlan 25
name "VLAN25"
untagged A20-A24
ip address 10.38.10.1 255.255.255.0
exit
ip multicast-routing
router rip
exit
router pim
state-refresh 45
trap hardware-mrt-full
exit
Figure 3-3. Example of Configuring PIM-DM on a Routing Switch at the Global Level
3-14
Enables IP routing.
Enables multicast routing.
Enables RIP.
Exits from the RIP context.
Enables PIM and enters the PIM context.
Configures a non-default State Refresh timer.
Sets an SNMP trap to notify an SNMP
management station if the hardware
multicast routing table fills with active flows.