DieHard Portable Power 1150 Operator's Manual page 13

8.7 Using the Inflator
Risk of explosion.
Read instructions of the product being inflated before using the
inflator. Avoid over inflation, do not exceed the manufacturer's
recommended pressures. Do not leave the inflator unattended
during use.
1. Ensure that the battery clips are securely on the storage holders.
2. Attach the corrugated hose with end adapter to the high-flow inflator port
located near the inflator ON/OFF switch on the back of the jump starter.
3. The main accessory adapter attached to the corrugated hose
accommodates up to 4 sizes. If another size is needed, an additional
adapter can be attached to the end of the main accessory adapter.
4. Insert the adapter into the product to be inflated.
5. Push the Inflator switch to the ON position and inflate the product.
6. When product is inflated to the desired level, push the Inflator switch to the
OFF position and remove the adapter.
24" Beach Ball
Pool Raft
Queen-size Air Mattress
2 Person Boat
Times are estimates and will vary depending on size and product features.
8.8 Using the Deflator
1. Ensure that the battery clips are securely on the storage holders.
2. Attach the corrugated hose with the end adapter to the high-flow deflator
port which is located on the side of the jump starter.
3. The main accessory adapter attached to the corrugated hose
accommodates up to 4 sizes. If another size is needed, an additional
adapter can be attached to the end of the main accessory adapter.
4. Insert the adapter into the item to be deflated.
5. Push the Inflator switch to the ON position and deflate the item.
6. When the product is deflated to the desired level, push the Inflator switch to
the OFF position and remove the adapter.
8.9 Before Using the Inverter
Important Safety Instructions:
1. Keep the jump starter well ventilated in order to properly disperse heat
generated while it is in use. Make sure there are several inches of
clearance around the top and sides, and do not block the vents on the back
of the jump starter.
2.
Make sure the jump starter is not close to any potential source of
flammable fumes, gases or clothing.
3. Keep the jump starter dry.
4.
dO NOT allow the jump starter to come into contact with rain or moisture.
Estimated Time for Inflating
1 to 3 minutes
4 to 6 minutes
4 to 8 minutes
8 to 10 minutes
10
• •