DieHard Portable Power 1150 Operator's Manual page 12

3. Turn the Jump Starter On/Off switch to the ON position.
4. Turn the USB device on.
5. Reverse these steps when finished using the USB port.
6. Charge the jump starter as soon as possible after using the USB port.
8.5 Using the Built-In Light
1. Position the jump starter on a flat, stable surface near the intended
work area.
2. Ensure the battery clips are securely clipped on the storage holders.
3. Press the Light Switch to the ON position.
4. The jump starter light will turn on and illuminate your work area.
5. Press the Light Switch to the OFF position.
6. Charge the jump starter as soon as possible after using the built-in light.
8.6 Using the Air Compressor
Risk of explosion.
Read the instructions of the product being inflated before using the
compressor. Avoid over inflation, do not exceed the manufacturer's
recommended pressures. do not leave the air compressor
unattended during use.
1. Ensure that the battery clips are securely on the storage holders.
2. Remove the air compressor hose from the storage compartment in the
back of the jump starter. Install adapters as necessary.
3. Attach the air compressor hose to the product or accessory to be inflated
by flipping down the lever.
4. Place the Inverter/Compressor Switch in the COMPRESSOR position and
inflate the product.
5. When the product is inflated to the proper air pressure (using the air
compressor gauge) place the Inverter/Compressor Switch in the OFF
position and remove the hose.
6. do not run for more than 10 minutes maximum at a time. Allow the jump
starter to cool down for 10 minutes before using again.
NOTE: To prevent overheating, the compressor has built-in thermal protection
that will turn the compressor off before it overheats. If the compressor shuts
off, wait a few minutes and it will automatically restart when the
compressor cools.
NOTE: The air compressor is rated for 150 PSI.
vehicle Tires 13" to 16"
Bike Tire
Sports Balls
These times are approximate, use the air compressor gauge to ensure the
proper pressure has been reached. Do not over inflate.
Estimated Time for Inflating
6 to 24 minutes
1 to 3 minutes
30 seconds
9
• •