Maintenance Instructions - DieHard Portable Power 1150 Operator's Manual

8. Fluorescent and High Intensity Lamps (with a Ballast); and
9.
Transformerless Battery Chargers.
doing so, may cause the device to run warmer or overheat.
8.11 Powering a 120v AC Device
To operate a 120v AC device:
1. Ensure that the battery clips are securely on the storage holders.
2. Open the protective cover of the AC power outlet on the front panel of the
jump starter.
3. Make sure the 120v AC device to be operated is turned OFF.
4. Plug the 120v AC device into the AC power outlet, and turn the Inverter/
Compressor Switch to the INvERTER position.
5. Turn the device on.
6. If the device does not operate properly when first connected to the
inverter, push the inverter rocker switch ON, OFF, and ON again in quick
succession. If this procedure is not successful, it is likely that the inverter
does not have the required capacity to operate the device intended.
7. Charge the jump starter as soon as possible after each use.
Risk of electric shock.
Incorrect operation of your inverter may result in damage and
personal injury. The inverter output is 120v AC and can shock or
electrocute the same as any ordinary household AC wall outlet.
120v AC Electrical Device Example Run-Time Chart
Appliance Type
Spotlights, Sump Pumps, dvd Players
Faxes, Tvs, Small Power Tools
Computer Printer, Medium Power
Tools, Blenders
NOTE: These are estimated run-times, actual time may vary. Times are
based on the internal battery being new, fully charged and operated at
room temperature
NOTE: The maximum continuous load is 400 watts. do not use the inverter
with a product that draws more than 400 watts, as this may cause damage to
the inverter and the product.
9.

MAINTENANCE INSTRUCTIONS

9.1 After use and before performing maintenance, unplug and disconnect the jump
starter (see sections 3 and 4).
9.2 Use a dry cloth to wipe all battery corrosion and other dirt or oil from the
battery clips, cords, and the jump starter case.
9.3 Ensure that all of the jump starter components are in place and in good
working condition, for example, the plastic boots on the battery clips.
9.4 Servicing does not require opening the unit, as there are no user-
serviceable parts.
9.5 All other servicing should be performed by qualified service personal.
Estimated Power
100 Watts
150 Watts
200 Watts
12
• •
Estimated Time*
1.5 Hours
1.25 Hours
55 Minutes