Printhead Removal - Epson Stylus C50 Service Manual

EPSON Stylus C50/C60/C61/C62

4.3.2 Printhead removal

1. Remove the Upper housing from the printer. (Refer to Section 4.3.1)
2. Open the Cover cartridge, and remove the both black and color ink cartridges.
3. Remove the both Cover cartridges from the CR unit.
4. Release two hooks for securing the Head FFC holder, and remove the Head FFC
holder from the CR unit.
Spacer FFC
Cable holder
The length of the Head FFC is
difference among each model.
Figure 4-7. Head FFC holder removal
Disassembly and Assembly
Hooks for Head FFC
SC61/C62 > SC60 > SC50
5. Remove two screws (C.B.P-TITE SCREW 3x8 F/Zn, +BIND B-TITE SEMS W2
2.5x5 F/Zb) for tightening the Printhead, and remove the Printhead from the CR
unit in the order indicated in the following figure.
2
C.B.P-TITE SCREW, 3x8, F/Zn
Figure 4-8. Printhead removal
6. Disconnect the Head FFC from the connector on the Printhead.
Disassembly
This figure is the Stylus Photo 810/820. There is a
difference of the Printhead between the Stylus
C60 and the Stylus Photo 810/820.
- Stylus C50/C60/C61/C62 : Printhead for 4col.
- Stylus Photo 810/820 : Printhead for 6col.
1
+BIND B-TITE SEMS, W2 2.5x5, F/Zb
(This screw is used only for the Stylus C60)
Revision C
95