Disassembly - Epson Stylus C50 Service Manual

EPSON Stylus C50/C60/C61/C62

4.3 Disassembly

The flowchart below shows step-by-step disassembly procedures. When disassembling
each unit, refer to the page number shown in the figure.
Upper housing removal
Page 93
Printhead removal
Page 95
CR unit removal
Page 97
CR motor removal
Page 100
*2)
Ink system unit removal
Page 120
*2) We recommend to replace to new Printer mechanism with the Lower housing to avoid the Main frame deformation by removing a part on the
Printer mechanism without the Lower housing (These units are not established for the service part individually). However, the these procedures
should be followed in the urgent case. In this time, the disassembly procedure is different depending on the removed unit.
* Ink system unit : ASF unit, CR unit, PSB/PSE unit, Holder shaft unit, Lower housing
* PF roller/PF motor : ASF unit, CR unit, PSB/PSE unit, Lower housing
*3) Unlike the paper eject roller shaft for the Stylus Photo 810/820, you cannot remove or replace the Paper eject roller from Printer mechanism.
This is because you cannot use the removed paper eject roller /spur gear again. Moreover, these parts are not established for service part.
Disassembly and Assembly
ASF unit removal
Page 101
PSB/PSE unit removal
Holder shaft unit removal
Page 103
*1) Lower housing removal (Including Paper eject roller removal *3)
Page 114
* The numbers in the figure of each section means the disassembling procedure of
PF roller removal
the specific part.
Page 123 * Each disassembly procedure explains how to disassemble individual part in the
units.
*1) Only when you replace the Lower housing with new one, you can remove the
PF motor removal
Printer mechanism from the printer. In this time, be careful not to deform the
Page 125
Main frame.
Figure 4-3. Disassembling flowchart
Disassembly
Circuit board removal
Page 106 Page 110
Revision C
Waste drain ink pad removal
Page 113
92