Videocon 325LDF User Manual page 6

Notes on wall mounting the TV
Wall mount items (sold separately) allow you to wall mount this TV onto a wall.
For detailed information on installing the wall mount, please see the instructions provided with the specific bracket.
Contact a technician for assistance when installing the TV on a wall mounted bracket.
• DO NOT install your wall mount while the TV is turned on. It may result in personal injury due to electric shock.
• Remove the stand and cover the stand mount recess with the cap originally supplied with the TV (see previous page)
Remote Control: Battery Installation
The remote control uses 2 x 1.5V AAA batteries.
For battery installation and replacement please
follow the instructions below..
1. Turn the remote control unit upside down.
Carefully press down on the grip of the
battery compartment - slide back and
remove the cover in the direction of the
arrow – see fig 1 and 2.
2. Install the new batteries making sure that
the battery polarity matches the + and –
guide inside the battery compartment . The
unit can be damaged if the batteries are not
positioned correctly – see fig 3
3. Close the battery compartment cover
carefully by sliding it in the direction
indicated – fig 4. It should click into place
once secured.
Cautions regarding the remote control unit
• Do not expose the remote control to
impacts – dropping, sitting on etc...
• Do not spill liquids on the remote control
and do not place in areas of high humidity.
• Do not leave in direct sunlight – the heat
may cause deformation of the unit.
• Remove the batteries from the remote
control if you are not using it for a long
period of time (several weeks)
• Do not throw away used batteries with
normal household waste.
• Do not mix new and used batteries.
•
Do not use rechargeable batteries.
• Do not mix battery types – (alkaline with
carbon, zinc etc)
• Do not expose batteries to excessive heat,
throw them on the fire, recharge them or
try to open them as this could cause them
to leak or explode.
1. Press
2. Slide and remove
(These figures are just for reference.)
Use the remote control by pointing it towards the
remote control sensor on the TV.....
If the remote control doesn't work, check the following:
Is the TV power on?
Are the batteries fitted correctly – plus and minus terminals ?
Are the batteries drained?
Is there a power outage, or is the power cord unplugged?
Are there objects between the remote and the TV sensor?
Ensure the remote is in TV Mode – Press the TV key.
Initial Setup
-
-
+
+
- -
- -
+ +
3. Fit the batteries
Remote control sensor
The remote control may not
work properly if the remote
control sensor on the TV is in
direct sunlight or bright lighting.
In such case , change the angle
of the lighting or TV, or operate
the remote control unit closer to
the remote sensor.
"Click"
4. Slide and Close
6