Videocon 325LDF User Manual page 27

Connecting External Equipment to the TV
PC IN [PC] / [AUDIO]: Connect to the video and audio output jack on your PC or Laptop.
1. Press the SOURCE key on the remote control
2. Use the up/ down ARROE keys to select VGA
3. Press ENTER to display PC
SETTING UP THE TV WITH YOUR PC/ LAPTOP
SCREEN menu is available only for VGA input and deactivated for other input sources.
The actual screens on your PC may be different depending upon your particular version of Windows and your particular
video card. Even if your actual screens look different, the same, basic set-up information will apply in almost all cases.
(If not, contact your computer manufacturer)
To access Screen menu you must be in VGA Mode – as per above.
Press ATV MENU on the remote – use the right ARROW key to select SCREEN Menu and the down ARROW to access Press ATV MENU on the remote – use the right ARROW key to select SCREEN Menu and the down ARROW to access
H Position - 5..0..+ 5
V Position - 5..0..+ 5
Phase 0 ~ 63
Clock - 3..0..+ 3
Auto
To set
Config
PIP setup Option
SCREEN MENU
Adjust the PC's screen positioning if it does not fit the TV screen.
Press the ▲ or ▼ button to adjusting the Vertical-Position.
Press the ◄ or ► button to adjust the Horizontal-Position.
The purpose of phase and clock adjustment is to remove or reduce picture noise. If the noise
is not removed by Phase alone, then adjust the frequency as best as possible with clock.
After the noise has been reduced, readjust the picture so that it is aligned on the center of
screen.
Press the ▲ or ▼ button to select "Phase" or "Clock", then press the [ENTER] button.
Press the ◄ or ► button to adjust the screen quality.
Auto Config allows the PC screen of set self-adjust to the incoming PC video signal.
This automatically sets the H-Position, V-Position, Phase and Clock.
If picture is not ok with Auto Config then adjust H-Position, V-Position, Phase and Clock
manually to adjust to the desired picture settings.
ON / OFF
PIP input
Select this option to activate/deactivate the
PIP function (picture in picture)
You can display a sub picture within the PC
main screen.
In this way, you can watch the picture of set
programme or video input from any
connected equipment while PC sceen is
active.
27