Initial Setup - Videocon 325LDF User Manual

3.
Before Starting
Please note the following important points!
1. Two people should lift or carry the TV!
2. Ensure you have plenty of space to work in safely!
3. A screw driver is required to fit the stand!
4. When fitting the stand ensure that the area you lay the TV face down on, is flat, stable and cushioned to prevent
damage to the screen!
5. Carefully remove the TV and accessories from the box supplied in – retain this and any packaging for 28 days
before disposing of.
In the Box/ Standard Accessories
1 x LCD Television
1 x Stand Mount
1 x Quick Start Guide
1 x User's Manual
If any of the above items are missing please consult your retailer or contact service on the number below!
Fitting the Stand Mount to the TV
Remove the TV panel from the box and place face down on a
flat, cushioned surface (take care not to damage the screen)
1. 1. Remove the cap from the bottom of the TV as shown Remove the cap from the bottom of the TV as shown
in fig 1 – retain for possible future use.
2. Insert the stand mount into the opening of the TV as
shown and carefully slide into position – fig 2. Please
ensure you correctly orientate the stand see fig 4.
3. Align the screw holes on the mount with the screw
apertures of the TV .
4. Insert and tighten the four screws (supplied) at the
rear of the TV as shown in fig 3 - take care not to over
tighten the screws.
5. Carefully lift the TV upright and position on a flat,
stable surface for viewing.
6. To detach the stand, perform the above steps in
reverse order.
Stand – Top View
Stand Column
2 x AAA Batteries (Remote)
4 x Stand Mount Screws
1 x Mains Cable
1 x Remote Control
Front
Back
fig 1
fig 2
fig 4 fig 3

Initial Setup

2
4
1
3
5