Videocon 325LDF User Manual page 13

First Installation
Remote Control Unit: Ensure that the remote control is in
TV mode – press the TV key (G - fig 1) – the remote will now
operate the TV.
With the TV connected and switched on as described
previously, follow the steps below to tune your TV into
standard terrestrial TV broadcasts'
ANALOGUE (STANDARD) TV TUNING
When the TV is switched on for the first time it may default
to Analogue Tuner Mode (Standard TV) – if not, to start
Analogue Tuning you must switch the TV into the TV Mode.
1. Press the SOURCE key (D) on the remote control –
the source input menu appears on screen (fig 2) –
this will only remain on screen for a few seconds for
you to select your option – if the menu disappears
simply press the SOURCE key again to display.
2. Use the up/ down
remote to highlight the TV option. Once highlighted
press the ENTER/ OK key (E) The TV will switch into
analogue tuner mode.
3. Press the ATV MENU key (F) to display the TV main 3. Press the ATV MENU key (F) to display the TV main
menu. The menu will default to the Video menu –
see fig 3 - Use the right
highlight the "Search" menu – see fig 4.
4. Press the down ARROW key (C) to highlight the
"Country" option and use the left or right
ARROW key (C) to select "ENGLAND"
5. Press the down ARROW key (C) to highlight "Auto
Search" and press the right
begin tuning.
6. An "Auto Program" banner will appear on the screen
- see fig 5 displaying a progress bar. All available
tuner frequencies will be searched and any channels
found, stored automatically to the tuner's memory.
7. This process will take a few minutes to complete.
When finished the TV "Auto Program" banner will
disappear and the TV will display a normal TV picture
(usually BBC 1). The TV is now ready to display all
available analogue TV broadcasts.
8. Provided the broadcast signal is strong enough, the
TV will automatically place all TV channels in the
correct order and label the channels BBC1, BBC2,
ITV, CH4, CH5. If the signal is weak then channels
may not be named and may be stored on the wrong
program position. If this is the case follow the
instructions on the next page.
Analogue TV Tuning: First Installation
ARROW keys (C) on the
ARROW key (C) to
ARROW key (C) to
KEY CONTROLS
A – POWER KEY
B – DTV MENU
C – ARROW KEYS
D – SOURCE KEY
E – ENTER or OK KEY
F – ATV MENU
G – TV KEY
fig 2
A
o
G
C E
F
D
fig 1
B
fig 3
fig 4
fig 5
13