Remote Control - Yamaha RX-V767 Owner's Manual

Remote control

Problem Cause
The remote control Wrong distance or angle.
does not work or
function properly.
Direct sunlight or lighting (from
an inverter type of fluorescent
lamp, strobe light, etc.) is striking
the remote control sensor of this
unit.
The batteries are weak.
The remote control ID of the
remote control and this unit do not
match.
External components The remote control code is not
cannot be controlled correctly set.
using the remote
control.
Even if the remote control code is
correctly set, there are some
models that do not respond to the
remote control.
See
Remedy
page
The remote control will function within a —
maximum range of 6 m, and no more than
30 degrees off-axis from the front panel.
Adjust the lighting angle, or reposition this —
unit.
Replace all batteries. 7
Match the remote control ID of this unit and 96
the remote control.
Set the remote control code correctly using —
"Remote control code search" on the CD-
ROM.
Try setting another code for the same —
manufacturer using "Remote control code
search" on the CD-ROM.
If this unit does not work when you press —
Cursor B / C / D / E, do the following.
When the key does not work during DVD
Input
disc menu operation: press the
selector again.
When there is no response with remote
control operation of the OPTION menu/
Setup menu: press SOURCE/RECEIVER
(it should glow orange) and try operating the
remote control again.
—
Problem Cause
The remote control The batteries of this remote
does not learn new control and/or the other remote
functions. control are too weak.
The distance between the two
remote controls is too long or too
short.
The signal coding or modulation
of the other remote control is not
compatible with this remote
control.
Memory capacity is full.
APPENDIX
Troubleshooting
See
Remedy
page
Replace the batteries. 7
Place the remote controls at a proper 97
distance.
Learning is not possible. —
Delete unnecessary functions to free some 99
memory space for the new functions.
115
En