Changing Batteries And Notices; Unit Indlcation Section; Unit On/Off Button - Toyotomi GAG-A128GVR Service Manual

Function and Control

6.2 Changing batteries and notices

Slightly to press the place with
1.
remote control. (As show in figure)
2 Take out the old batteries. (As show in figure)
3.
Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
(As show in figure)
4
Attach the back cover of wireless remote control. (As show in figure)
NOTE:
When changing the batteries, do not use the old or different batteries,
otherwise, it can cause the malfunction of the wireless remote control.
If the wireless remote control will not be used for a long time, please
take them out, and don't let the leakage liquid damage the wireless
remote control.
The operation should be in its receiving range.
It should be placed at where is 1m away from the TV set or stereo sound sets.
If the wireless remote control can not operate normally, please take them out,
after 30s later and reinsert, if they cannot normally run, please change them.

6.3 Unit indlcation section

1. When the unit is energized, all the display marks will be shown and
only the power LED lights.
2. When the unit is turned on remotely, the power LED goes out whil e
the current setting running mode is displayed.
3. During defrosting, "H1" is displayed in "dual 8".
4. In normal situation, the setting temperature is displayed in "dual 8
" place.
5. When the signal of displaying indoor temperature or outdo or
temperature is received from the controller , the corresponding
temperature will be shown in "dual 8" place. It resumes displaying
setting temperature 5s later.

6.4 Unit ON/OFF button

If the wireless remote control is lost or broken, please use the manual switch button. At this time, the unit will run at the
Auto mode, but the temperature and fan speed cannot be changed. The operation was shown as below:
To open the panel, the manual switch is on the displayer box.
Turn on the unit: At unit turned off, press the button,the unit will run at Auto mode immediately.The microcomputer will accord to
the indoor temperature to select (Cooling, Heating, Fan) and obtain the comfortable effect.
Turn off the unit: At unit turned on, press the button, the unit will stop working.
Operation of automatic buttons:
, along the arrowhead direction to push the back cover of wireless
Sketch map for
changing batteries
ON/OFF
COOL light (blue)
DRY light (green)
RUN light (red)
HEAT light (orange)
Unit ON/OFF button
21