Changing Batteries And Notices; Unit Indication Section; Unit On/Off Button - Toyotomi GAN-A180GVR Service Manual

B
Remove the battery cover plate from the rear of the remote controller. (As shown in the figure)
1.
Take out the old batteries.
2
3.
Insert two new AAA1.5V dry batteries and pay attention to the polarity.
4 Reinstall the battery cover plate.
NOTE:
When replacing the batteries, do not use old or different batteries,
otherwise, it may cause malfunction.
If the wireless remote controller will not be used for a long time, please
remove batteries to prevent damage from leaking batteries.
The operation should be performed in its receiving range.
It should be kept 1m away from the TV set or stereo sound sets.
If the wireless remote controller does not operate normally, please take
the batteries out and replace them after 30 seconds. If it still can't operate
properly, replace the batteries.
B
ler
fter is
fter is
operation
during stop
operation
during running
operation during stop
communication error
N
S
less than 5s
start running
stop running
(after running, abnormal)
Sketch map for
changing batteries
ON/OFF
keep 5 ~ 10 s
start compulsory running stop compulsory running
(avoid button lock)
stop running
COOL light (blue)
DRY light (green)
RUN light (red)
HEAT light (orange)

Unit ON/OFF button

keep more than 10s