Remote Controller Setting - Furuno 1833 Installation Manual

3.7

Remote Controller Setting

A remote controller can be set exclusively for use with a specific display unit, in the case of
multiple NavNet display units. Set the remote controller mode desired on the menu and
attach appropriate label (supplied with accessories) to the remote controller and display
unit.
1. Press the [MENU] key, SYSTEM CONFIGURATION soft key, GENERAL SETUP soft
key in order to show the GENERAL SETUP menu.
KEY BEEP
ON
LANGUAGE
ENGLISH
RANGE UNIT
nm, kt
TEMPERATURE UNIT
°
F
DEPTH UNIT
ft
TEMPERATURE SOURCE
NMEA
DEPTH SOURCE
NMEA
RESET TRIP LOG
NO
2. Press the NEXT PAGE soft key to show Page 2.
3. Select INFRARED REMOTE MODE, and press the EDIT soft key.
The SELECT I/R REMOTE window appears.
4. Point the remote controller toward the display unit, and press any key (except [ENTER]
key) on the remote controller. The remote controller mode window appears.
5. After confirming the remote controller mode on the window, press the [0] and [2] key
together on the remote controller to change the controller mode setting among A, B, C
and D.
6. Operate the trackball or [ENTER] knob so that the display mode should be the same as
the controller mode setting.
7. Press the [MENU] key to close the menu.
GENERAL
SETUP 1
EDIT
NEXT
PAGE
RETURN
Page 1
GENERAL SETUP menu
SELECT I/R REMOTE
A
B
MODE
C
A
D
PRESS '0' AND '2' KEY
TOGETHER TO CHANGE MODE.
Select I/R REMOTE window
LAT/LON DISPLAY
DD° MM.MMM'
TD DISPLAY
LORAN C
SPEED
SOG
POSITION DISPLAY
LAT/LON
TIME DISPLAY
24 HOURS
INFRARED REMOTE MODE
A
RANGE & BEARING MODE
RHUMB LINE
BEARING READOUT
MAGNETIC
MAGNETIC VARIATION
AUTO 7.0° W
VIDEO BOOST TIME
3 minutes
Page 2
Remote controller
mode window
GENERAL
SETUP 2
EDIT
PREV.
PAGE
3-17