Furuno 1833 Installation Manual page 50

5. Attach the cable tie supplied as installation material to the position shown above, and
then tie the cable with it.
6. Reassemble the display unit. Fix the ground wire of the RGB output cable with the pan
head screw shown above.
7 Attach the rubber grommet to the hole at the rear of the display unit.
4-4
Connector Nut
(Large) 1 pc.
5 pcs.
Cable tie
J106
How to connect the RGB output cable
24P Connector Nut
Rubber grommet
Cut a "X" in the
(Small) 4 pcs.
rubber grommet.
Use this pan head
screw to fix the
ground wire of the
RGB output cable.
Remove
connector cover.