Furuno 1833 Installation Manual page 44

7. Select sentence and press the ON/OFF soft key to show ON (output) or OFF (no output)
as appropriate.
8. Press the RETURN soft key.
9. Press the [MENU] key to quit.
Item
FURUNO GPS Selects whether the GPS Receiver
Sensor GP-310B/320B is connected to the
DATA1 port or not.
Output Format Selects NMEA output version of the
equipment connected.
Lat/Lon Format Selects latitude/longitude format to
output.
Output Destination Selects whether to output route (data
sentence RTE) and waypoint data (data
sentence WPL) when destination is set.
SELECT SNTNC Selects data sentence(s) to output. Select sentence with the trackball and press the
(soft key) ON/OFF soft key to show ON or "- -" (OFF) as appropriate. See the figure above for
sentence and default settings.
Item Description
NMEA Output Selects NMEA output format.
Format
Baud Rate Sets baud rate.
Bit Length Sets character length.
Stop Bit Sets number of stop bits.
Parity Sets parity bit.
SELECT Chooses data sentences to output. For further details see the illustration "NMEA data
SNTNC sentences" on page 3-15.
(soft key)
3-16
Contents of DATA 1 PORT menus
Description
Contents of DATA 3 PORT menu
Settings
Yes, No No
NMEA0183 Ver. NMEA0183 Ver. 2.0
1.5, NMEA0183
Ver. 2.0
DD°MM.MM', DD°MM.MMM'
DD°MM.MMM,
DD°MM.MMMM'
Yes, No No
Settings
NMEA Ver. 1.5, NMEA
Ver. 2.0
4800, 9600, 19200 (bps) 4800(bps)
8 bit, 7 bit
1 bit, 2 bit
Even, Odd, None
Default Setting
Default Setting
NMEA Ver. 2.0
8 bit
1 bit
None