Furuno 1833 Installation Manual page 10

1.1.1 Mounting procedure
Tabletop, overhead mounting
Follow the procedure below to mount the display unit on a tabletop or the overhead.
1. Fix the hanger by four tapping screw.
2. Screw knob bolts in display unit, set it to hanger, and tighten knob bolts.
3. Attach hard cover to protect CRT.
Note: For overhead mounting, reinforce the mounting location and secure the hanger will
bolts, nuts and washers (local supply).
Flush mounting
Note: Use supplied six pan head screws when the thickness of the bulkhead is from 11 to
14 mm. For bulkhead which exceeds 14 mm in thickness the length of the pan head
screws should be bulkhead thickness (A) plus 7.8 ±2 mm. Also the length of B should
be max. 8 mm.
1-2
Tapping screws
(4 pcs.)
Anti-vibration
rubber
Hanger
Tabletop, overhead mounting of display unit
B
Fixing screw, side view
Display unit
Knob bolts (2 pcs.)
A