Fixed Glass Assembly; Install Trim And/Or Surround; Air Shutter Setting - Heat & Glo SL-750TRS-IPI-E Owner's Manual

H. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
• Pull the four glass assembly latches out of the groove on
the glass frame. Remove glass door from the appliance
(see Figure 14.9).
Replacing Fixed Glass Assembly
• Replace the glass door on the appliance. Pull out and
latch the four glass assembly latches into the groove on
the glass frame.
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
Figure 14.9 Fixed Glass Assembly
I. Install Trim and/or Surround
• Install optional trim kits and/or surrounds using the
instructions included with the accessory.
• Use non-combustible materials to cover the gap between
the sheet rock and the appliance (when applicable to the
model).
Heat & Glo • SL-750TRS-IPI-E, SL-550TRS-IPI-E, SL-350TRS-IPI • 2120-901 Rev. U • 11/13
J. Air Shutter Setting
SL-550TRS-IPI and SL-750TRS-IPI ONLY
This appliance has an adjustable air shutter (which con-
trols the primary air) factory set for the minimum vertical
vent run. If your installation has more than the minimum
required vertical vent length, adjustment of the air shutter
may be necessary to obtain optimal fl ame appearance.
This should be adjusted by a qualifi ed installer at the
time of installation.
SL-350TRS-IPI ONLY
By sliding the air shutter to the right, you will be closing
the air shutter. To adjust loosen the wing nut (see Figure
14.10). Care should be taken when adjusting the air shut-
ter so as not to cause the appliance to soot. If sooting oc-
curs the air shutter will need to be opened by sliding the
air shutter to the left. When fi nished, tighten wing nut.
NOTICE: If sooting occurs, provide more air by opening
the air shutter.
SL-350TRS-IPI ONLY
Figure 14.10 Air Shutter
Shutter Settings
SL-350TRS-IPI
SL-350TRS-IPI (LP)
SL-550TRS-IPI-E
SL-550TRS-E
SL-550TRSIPILPE
SL-550TRSLP-E
SL-750TRS-IPI-E
SL-750TRS-E
SL-750TRSLPIPIE
SHUTTER ADJUSTMENTS
3/16 in.
1/4 in.
3/8 in.
Fixed
3/8 in.
Fixed
71