Front Blower Installation - Lopi Freedom Owner's Manual

O
PTIONAL
P 32
AGE
S P
URROUND ANEL
3. Some kits include double-back tape. For those kits, follow the instructions below.
F B I
RONT LOWER
The front blower is designed to improve the natural convection of the appliance by pushing air through
the convection chamber of the appliance and causing the heated air to exit through the vents along the
top of the appliance. It attaches below the ashlip. Operating instructions are described in the section
"Blower Operation" on page 16. The directions below detail its installation.
1. Remove the two screws located underneath the ashlip (see the illustration below).
2. Place the blower underneath the ashlip and re-attach the screws. Before tightening the screws,
lift up on the blower so that it tucks up underneath the ashlip closely.
E
QUIPMENT
I (C
NSTALLATION
Attach a square of double-back tape to each of the bottom corners of the surround
panels before installing the trim. This will keep the panels from flaring at the bottom.
NSTALLATION
(P
ART NUMBER
Use a 3/8"
nutdriver to
attach the two
screws that hold
the front blower
to the appliance.
(C )
ONTINUED
)
ONTINUED
99000133)
Surround
Surround Panel
Panel
Brass Trim
Plug the blower
into a 110 volt
grounded outlet.
Control Box