Remove the strain relief by
squeezing it from the top and bottom
with a pair of slip-joint pliers.
Remove the two screws here
Use a 3/8" nutdriver to replace the two screws
and hold the front blower to the appliance.
The wires tuck in here, directly
behind the blower cage.
Disconnect the molex plug inside the
blower assembly. Remove the power
cord by pulling it out of the hole
exposed by removing the strain relief.
Left Side of
Blower
Assembly
Remove the button plug from the
left side and insert it into the hole
on the right side.
Plug the
blower into a
110 volt
grounded
outlet.
Control Box