Connecting A Basic 5.1-Channel Surround System - Denon DVD-3800 Operating Instructions Manual

Analog 5.1.channel audio signals can be output from the DVD-3800.
The multichannel audio signals recorded in packed PCM can be played when an AV amplifier equipped with analog 5.1~channel audio
inputs is connected.
To power outlet
DVD-3800
El
Center speaker
Front speaker (left)
Front speaker (right)
Subwoofer
Surround speaker (left) 1
II I I
Surround speaker (right)
~
IIIJ
-
AV amplifier wrth 5.1.channel inpur terminals
0
NOTES:
l
For multi-channel connections, set "AUDIO CHANNEL" under "AUDIO SETUP" at "SETUP" to "MULTI CHANNEL" and make
the "SPEAKER CONFIGURATION",
"CHANNEL LEVEL" and "DELAY TIME" settings.
l
Set "LPCM (44.1 kHz/48 kHz)" under "AUDIO SETUP" at "SETUP" to "OFF". (See page 33.)
(If set to "ON", analog audio signals converted to 48 kHz or less will be output for linear PCM or packed PCM sources.)
l
When playrng DVDs that are not copyright-protected and the unit is set to output digital and analog audio signals simultaneously,
for some discs only the signals below 96 kHz for the front two channels will be output for the analog part.
When playing DVDs that are not copyright-protected, set "DIGITAL OUTPUT" at "PURE DIRECT MODE" to "OFF". (See page 43.)
l
With the DVD-3800, we recommend turning the digital output off and only outputting analog signals in order to keep interference
from the digital output circuitry to the minimum and allow you to enjoy high bit, high sampling frequency, high quality multi-
channel sound.
14