Travis Industries 31 DVI GSB2 Owner's Manual page 36

36 Optional Equipment
6. Replace the manifold cover.
7. Install the LP pilot orifice following the instructions below.
(a) Use a 7/16" open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then replace
the pilot hood, tightening the pilot hood until it is snug (do not over-tighten).
a
© Travis Industries
(
for qualified installers only)
Natural Gas Orifice = .020N (3way)
.018N (2way)
LP (Propane) Orifce = .014LP
7/16" Wrench
4140813
b
.020N
or
.018N
.014LP
100-01296