Subaru Impreza 2004 Service Manual page 72

3) Remove the bushing, spacer and spring.
(1) Plug
(2) Stopper
(3) Brake pedal
(4) Brake pedal spring
4) Remove the brake pedal pad.
5. RHD AT MODEL
Do not disassemble the brake pedal because it has
non-disassemble structure.
6. RHD MT MODEL
Do not disassemble the brake pedal because it has
non-disassemble structure.
D: ASSEMBLY
1) Attach the stop light switch, etc. to pedal bracket
temporarily.
2) Clean the inside of bores of clutch pedal and
brake pedal, apply grease, and set the bushings
into bores.
3) Align bores of the pedal bracket, clutch pedal
and brake pedal, attach the brake pedal return
spring and clutch pedal effort reducing spring
(model with hill holder), and then install the pedal
bolt.
NOTE:
Clean up the inside of bushings and apply grease
before installing spacer.
Tightening torque:
T: 29 N·m (3.0 kgf-m, 21.7 ft-lb)
T
Brake Pedal
4) Adjust the stop light switch position after install-
ing the brake pedal to vehicle.
E: INSPECTION
1) Move the brake and clutch pedal pads in the lat-
eral direction with a force of approx. 10 N (1 kgf, 2
lb) to ensure pedal deflection is in specified range.
CAUTION:
If excessive deflection is noted, replace the
bushings with new ones.
Deflection of brake and clutch pedal:
BR-00101
Service limit
2) Check the position of pedal pad.
Pedal height: L
148 mm (5.83 in)
BR-00102
BR-71
5.0 mm (0.197 in) or less
(1)
(1) Clutch pedal
(2) Brake pedal
(1) Brake pedal
BRAKE
(2)
BR-00104
(1)
BR-00105