Subaru Impreza 2004 Service Manual page 39

BRAKE
4) Remove the clip.
(1) Clip
5) Remove the pad pins and cross spring.
(2)
(1) Cross spring
(2) Pad pin
6) Expand the pads and push piston back.
7) Remove the pad.
(1) Rear brake pad
B: INSTALLATION
1. 14 INCH TYPE
1) Apply a thin coat of Molykote AS880N (Part No.
K0777YA010) to the frictional portion between pad
and pad clip.
2) Install the pad on support.
3) Install the caliper body on support.
Tightening torque:
37 N·m (3.8 kgf-m, 27.5 ft-lb)
Rear Brake Pad
(1)
BR-00313
(1)
BR-00311
(1)
BR-00312
NOTE:
If it is difficult to push the piston during pad replace-
ment, loosen air bleeder to facilitate work.
2. 15 INCH TYPE
1) Apply a thin coat of Molykote AS880N (Part No.
K0777YA010) to frictional portion between pad and
pad inner shim.
2) Install the pads on caliper body.
3) Install the cross spring.
4) Install the pad pins on caliper body.
5) Install the M clip.
3. 17 INCH TYPE
1) Apply a thin coat of Molykote AS880N (Part No.
K0777YA010) to frictional portion between pad and
pad inner shim.
2) Install the pads on caliper body.
3) Install the cross spring and pad pins.
4) Install the Clip.
C: INSPECTION
1. 14 INCH TYPE
Check pad thickness A.
Pad thickness
NOTE:
• Always replace the pads for both right and left
wheels at the same time.
• Also replace the pad clips if they are twisted or
worn.
• A wear indicator is provided on the inner disc
brake pad. If the pad wears down to such an extent
that the end of wear indicator contacts disc rotor, a
squeaking sound is produced as the wheel rotates.
If this sound is heard, replace the pad.
• Replace the pad if there is oil or grease on it.
BR-38
A
Standard value 9.0 mm (0.354 in)
Wear limit 1.5 mm (0.059 in)
BR-00016