Subaru Impreza 2004 Service Manual page 36

6) Position the boot in grooves on cylinder and pis-
ton.
(3)
(2)
(1)
(1) Piston
(2) Piston boot
(3) Caliper body
(4) Piston seal
7) Apply a coat of specified grease to the lock pin
and guide pin outer surface, cylinder inner surface,
and boot grooves.
Grease:
NIGLUBE RX-2 (Part No. K0779GA102)
8) Install the lock and guide pin boot on support.
(1)
(1) Pin boot
(2) Lock pin or guide pin
(3) Apply grease.
2. 16 INCH TYPE
1) Clean the caliper body interior using brake fluid.
2) Apply a coat of brake fluid to the piston seal and
fit piston seal in groove on caliper body.
3) Apply a coat of brake fluid to the entire inner sur-
face of cylinder and outer surface of piston.
4) Apply a coat of specified grease to the boot and
fit in groove on ends of cylinder and piston.
Grease:
NIGLUBE RX-2 (Part No. K0779GA102)
5) Insert the piston into cylinder.
Front Disc Brake Assembly
(4)
BR-00122
: (3)
(2)
BR-00030
CAUTION:
Do not force the piston into cylinder.
6) Position the boot in grooves on cylinder and pis-
ton.
(1) Piston
(2) Piston boot
(3) Piston seal
(4) Boot ring
7) Install the boot ring. Be careful not scratch the
boot.
3. 17 INCH TYPE
1) Clean the caliper body interior using brake fluid.
2) Apply a coat of brake fluid to the piston seal, and
then install the piston seal in groove on caliper
body.
3) Apply a coat of brake fluid to the entire inner sur-
face of cylinder and outer surface of piston.
4) Apply a coat of specified grease to the boot and
install it in the groove on piston.
Grease:
NIGLUBE RX-2 (Part No. K0779GA102)
5) Insert the piston into cylinder.
BR-35
(1)
(2)
(4)
(3)
BRAKE
BR-00307
BR-00308