Subaru Impreza 2004 Service Manual page 67

BRAKE
2. REAR BRAKE HOSE (DISC BRAKE)
1) Pass the brake hose through hole of bracket,
and then lightly tighten the flare nut to connect
brake pipe.
2) Insert the clamp upward to fix brake hose.
3) Install the brake hose to caliper using a new gas-
ket.
Tightening torque (Union bolt):
18 N·m (1.8 kgf-m, 13.0 ft-lb)
4) While holding the hexagonal part of brake hose
fitting with a wrench, tighten the flare nut to the
specified torque.
Tightening torque (Brake pipe flare nut):
15 N·m (1.5 kgf-m, 10.8 ft-lb)
(2)
(1)
(1) Brake pipe
(2) Brake hose
(3) Brake hose clamp
5) Bleed air from the brake system.
3. REAR BRAKE HOSE (DRUM BRAKE)
1) Install the brake hose to wheel cylinder.
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
2) Secure the brake hose to bracket on strut using
a clamp.
3) Connect the brake hose through hole in bracket
on body.
Brake Hose
(3)
(3)
BR-00096
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
(2)
(1) Brake pipe
(2) Brake hose
(3) Brake hose clamp
4) Bleed air from the brake system.
C: INSPECTION
Ensure there are no cracks, breakage, or damage
on the hoses. Check the joints for fluid leakage. If
any cracks, breakage, damage or leakage is found,
repair or replace the hose.
BR-66
(1)
(2)
(3)
(1)
(3)
BR-00126