Vibration Zones; Atm Zones; Forced Set; Selecting Forces Set - ADT Galaxy 8 User Manual

Galaxy 8/18/60/500/512
ATM PIN + ent
[ent] to Select
1=ATM-1
>A
[ent] to Select
2=ATM-2
ent
DELAY ACCESS
ATM-2 12 mins
ACCESS TIMEOUT
ATM-2 10 mins
ATM PIN + ent
1=RESET ACCESS
2=ABORT ACCESS
1
PIN + ent
0 = OMIT ZONES
[ent] to select
1

1 = FORCED SET

[ent] to select
ent
3 OMITTED 120
2 Zones Open
[<] [>] to View
Option not
available
Technical Manuals Online! - http://www.tech-man.com

VIBRATION ZONES

If the omitted zone is a vibration zone, then all zones of this type (in
all groups) will be block omitted. The vibration zones remain omitted
until manually reinstated. Unsetting the system does not reinstate
vibration detectors.
ATM 1/2/3/4 ZONES
ATM zones are omitted by entering one of the ten ATM codes (user
188 to user 197). To select this option enter an ATM code followed
by the ent key. Use the A> key to scroll through the four ATM zone
options (ATM1 to ATM4) and select by pressing the ent key. A
predetermined ATM delay time will expire before omitting all ATM
zones with the selected ATM zone type. The zones will be omitted
for the duration of the ATM time-out period and the remaining time
in minutes will be displayed on the initiating keypad. A warning is
given ten and five minutes before the zones are reinstated. The ATM
Time-out period can be extended by entering an ATM code and
selecting 1=Reset Access. To manually reinstate ATM zones, enter
an ATM code and select 2=Abort Access.
FORCED SET (User Level 3 and above)
PURPOSE
The FORCED SET option allows the user to automatically omit
zones, eligible for omission, which are open when the system setting
routine is started. Zones omitted in this way remain omitted for one
set period only. This option is not available on the Galaxy 512.
SELECTING FORCED SET
Access the QUICK MENU. Press key 1 followed by the ent key. The
display indicates how many zones have been omitted and the number
of seconds left before setting.

NON-OMITTABLE ZONES

Some open zones may not be eligible for omission from the system.
In this case the display indicates which zones are open and the exit
time is reset. These zones must be closed before setting can continue.
OPTION NOT AVAILABLE
This option is provided by the engineer, where it is specifically
required. Attempting to select an option when it has not been pro-
vided results in the display of OPTION NOT AVAILABLE.
9 User Guide