Sherwood RD-705i Operating Instructions Manual page 52

RD-705i(G)_ENG_101206_RD-705i(G)_ENG 2010-12-07 오전 10:25 페이지 52
When selecting the SPEAkER DISTANCE
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the "SPK DISTANCE", then press the ENTER
button.
2.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired item.
3.
Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to set the selected item as desired.
4.
Repeat the above steps 2 and 3 until the distances are all set as desired.
■About the speaker distance
When enjoying multi-channel surround playback with Dolby Digital and DTS sources, etc., it is ideal that the center, surround and
surround back speakers, etc. should be the same distance from the main listening position as the front speakers. By entering the
distance between the listening position and each speaker, the delay times of center, surround and surround back speakers, etc.
are automatically adjusted to create an ideal listening environment virtually as if the center, surround and surround back
speakers, etc. were at their ideal locations respectively.
AT
S P K D I S T A N C E
U N I T : M E ERS T
■Note :
• You cannot select the speakers set to "NO".
■When selecting the desired unit
• You can select either "METERS" or "FEET".
• Once a unit is selected, the distances are automatically
changed in the selected unit.
■When setting the distance
• You can set the distance within the range of 0.1 ~ 9.0
meters in 0.1 meter intervals (or 0.5 ~ 30.0 feet in 0.5 feet
intervals).
52
3 0