Installation; Unit Operation - Bypass - Konica Minolta GP-502 Operation Manual

3. Installation

The GP-502 should only be installed by a Customer Engineer (CE). Please contact service representative for
installation of this finisher with the host printer.
1. Power Inlet:
The power inlet is located on the rear of the GP-502. Attach the included power cord to the GP-502 at
this location. Only use power that meets the voltage and frequency as listed on the rating label located
on the GP-502.
2. Power Switch:
The power switch is located on the rear of the GP-502.
NOTE: Setting the power switch to the off position will not turn off all power within
the GP-502. Power is passed through the GP-502 by and other finishers.

4. Unit Operation - Bypass

Whenever binding is not selected for the GP-502 bypass will be enabled. For bypass operation no
consideration needs to be made for media weight or size, all acceptable printer paper sizes and weights
can be bypassed.
R e v 1 .0 . . . .. . . .. . . . . .. . . .. . . .. . . .. . . .. . . .. . . .. . . .. . . .. . . .. . . 111111111111111 ''''''''''''''''''''''''
6
''J u ly. 2 0 1 2